Fuel Injection Pump

Yanmar Tractor Injector Pump

Includes:
New Injection Pump

Fitment Note:
Will ONLY fit the models where the steel injection lines screw directly into the top of the pump. Will NOT fit models where the steel lines screw onto banjo fittings that stick out of the side of the pump. In order to use this pump on a banjo style you will need to replace the steel lines with the straight in style. 

Recommended Items:
Injection Pump Shim Set (1 required)
Fuel Supply Hose (per foot)
Fuel Supply Hose Clamps (OEM Style)

Shop Warning!
These Yanmar Injection pumps are very durable. If your pump failed then odds are that there is something wrong with your fuel. Please flush your fuel system with clean, fresh fuel & install a new filter before installing this new pump or you might end up with the same problem. Warranty does not cover pumps that are damaged due to trash or water in the fuel system. 

Shop Notes #1:
You will really want to time the pump after installing. The timing is adjusted by the number of shims under the pump (between the pump & engine). You can usually get the tractor to run by just using the same shims that were under your old pump but to get it to run correctly you will want to time it. Full timing instructions can be found in the link below:
https://brandmparts.com/pages/yanmar-injection-pump-timing

Shop Notes #2:
Don't forget to bleed the air out of the system. See instructions on our bleeding fuel system article. 

Replaces : 724160-51701 724460-51701 724761-51700 724761-51701 IP-200